WHYNTER Eco Pure Air Purifier
MODEL# : AFR-300
SB/W
Instruction Manual
Thank you for your purchase of this WHYNTER product. Please read this Instruction Manual carefully before
using the product to ensure optimal performance. Keep this manual in a safe place for future reference.
1
Important Safety Instructions
To reduce the risk of fire, electrical shock, or injury when using your appliance, follow
these basic precautions:
1. Place the appliance on hard and level surface where it can not be easily knocked
down.
2. Do not use if the power supply cord is damaged. If damaged, it must be replaced by a
qualified electrician.
3. This appliance is not intended for use by young children or physically-challenged
persons without supervision/assistance. Young children must be supervised to ensure
safety around this or any appliance.
4. Always switch off and unplug the appliance when replacing filters, cleaning,
moving, or when not in use.
5. Keep the appliance away from any heat source, direct sunlight or area with excessive
moisture such as bathrooms and kitchens.
6. This air purifier is an electrical appliance. To avoid injury from electrical shock do not
operate the appliance with wet hands, while standing on a wet surface or while
standing near in water. Do not use outdoors or in wet conditions.
7. Avoid placing any objects on top of the appliance.
8. Never pull the cord to disconnect it from the power outlet. Grasp the plug and pull it
from the outlet.
9. Never lift or carry the appliance by the power cord.
10. This appliance is designed for household, non-commercial use only. Any other use will
void the warranty.
11. Do not try to disassemble, modify or repair the appliance by yourself.
12. Do not place the appliance upside down or on its side.
13. Do not block the air intake and air outlet.
14. When positioning the appliance, ensure that there is at least a 6” clearance around the
appliance. This allows for adequate ventilation.
15. If used with a humidifier, please keep this appliance away from the humidifier.
16. Never use harsh detergents or solvents to clean the appliance.
17. Do not operate the appliance without installing the filters.
18. Do not wash and reuse the Whynter HEPA filter. HEPA filters should only be
replaced, not cleaned.
.
3
This AFR-300 air purifier utilizes a complete 5-layer purification system which includes
a Pre-filter, HEPA filter, Activated carbon filter, Photo-catalyst filter and UV light. The
AFR-300 air purifier not only traps dust and dirt, it also destroys allergens such as
dust mites, pollen and pet epithelia. It kills over 99% of viruses, over 98% of bacteria
and over 94% of mold and fungus.
The conveniently compact size allows the Whynter Eco Pure air purifier to be moved
from room to room or from a home to the office as needed. With an effective range of
600 square feet, it is powerful enough to clean the air in any room.
Purification Technology
Pre-filter: The washable pre-filter filtrates large size allergens, dust and pet hair.
HEPA filter: HEPA stands for High Efficiency Particulates Air. The Whynter HEPA filer
is designed to remove 99.97% of all allergens such as bacteria, pollen, pet dander,
dust mite that we 0.3 microns or larger. (For reference, 1 microns is 1/100th of the
width of human hair.) Once the allergens are “trapped” by the HEPA filter, they are not
released back into the air.
Activated carbon filter: The washable activated carbon filter absorbs and removes
common household odors VOCs (volatile organic compound), chemical smells and
cigarette odor.
Ultraviolet (UV) light: Sterilizes airborne pathogens like germs, viruses and bacteria
that are too small to be captured by the HEPA filter.
Photo-catalyst filter: Photo-catalyst (TiO2) filter uses ultra violet light to breakdown
harmful gases in removing both particulate and gas contaminants from air. It purifies,
sterilizes and deodorizes air. It kills harmful bacteria thoroughly, decomposes organic
compounds (methanal, benzene, etc.) and inorganic compounds (nitrogen oxide,
sulphide, etc.), and inhibit mildew. It also has self-cleaning ability.
4
Technical Data
Model no.
AFR-300
Coverage Area
Voltage
600 Sq. Ft.
120v / 60Hz
>99.97%
76 Watts
<35dB
Purification efficiency
Input power
Noise level (at lowest setting)
Fan Speed
Air flow
4 adjustable speed
250 Square Meter per Hour Max. /
147 Cubic feet per minute Max.
16.5 lbs
Net weight
Product size(W×H×D)
16”” × 8.3” × 29.7”
5
PARTS OVERVIEW
1. Control Panel
6. Filter Frame
2. Front Cover
3. Front Cover Clip 4. Air Intake Vents 5. Pre-filter
7. HEPA Filter & 8. Photo-catalyst
Activated Carbon Filter
Filter
9. UV Lamp
10. Remote
Control holder
11. Handle
12. Air Outlet Vent 13. Fragrance
Diffuser
14. Power Cord
6
CONTROL PANEL & REMOTE CONTROL
1. ON/OFF: Turns on / off the air purifier.
2. FAN: Sets fan speed setting in the cycle of High –> Medium –> Low –> Silent.
3. SILENT: Sets the air purifier to run at a noise level below 35 dB to ensure sound
sleep. By pressing this button, this machine will be switched into the “SILENT” fan
mode.
4. SLEEP: Sets running time of the air purifier at SLIENT mode for 8 hours. In the
SLEEP mode, the TIMER function cannot be used.
5. UV Lamp: Turns on / off the photo-catalyst POC function.
6. UV Lamp indicator on LCD display: When the UV lamp is on, the screen displays
, the sun icon. When the screen displays
, it indicates that the UV lamp
needs to be replaced. The working life of a UV lamp is about 15,000 hours.
7. HEPA filter replacement indicator: When the HEPA filter replacement indicator
blinks on the LCD display, you need to change a new HEPA filter.
8. LED: The background of the LED light can be turned on and off.
9. Intentionally removed.
10. TIMER: By pressing “TIME” button once, “88:88” will be displayed, press the “+” &
“-” buttons to set the current time. When the air purifier is turned on, press the
“TIME” button twice quickly, “88:88 time off” will be displayed, then press the “+” & “-”
buttons to adjust the time off. When the machine is on Standby mode, press the
“TIME” button twice quickly, “88:88 time on” will be displayed, then press the “+” & “-”
buttons to adjust the activation time.
11. ANTI-POLLEN: Turns on the pollen-removing function. This mode of operation is
recommended for pollen season. The fan speed will run in a cycle of medium
speed for 5 minutes and low speed for 5 minutes.
7
REMOTE CONTROL OPERATION
1. ON/OFF: Turns on / off the air purifier.
2. LOCK: Press the “LOCK” (No. 2) button on remote control to lock the air
purifier. All the buttons on the air purifier and the remote control are disabled
except the “LOCK” button on the remote control. To unlock the air purifier,
press this button again. You can also unplug and restart the air purifier.
2. FAN: Sets fan speed setting in the cycle of High –> Medium –> Low –> Silent.
3. SILENT: Sets the air purifier to run at a noise level below 35 dB to ensure
sound sleep. By pressing this button, this machine will be switched into the
“SILENT” fan mode.
4. SLEEP: Sets running time of the air purifier at SLIENT mode for 8 hours. In the
SLEEP mode, the TIMER function cannot be used.
5. UV Lamp: Turns on / off the photo-catalyst POC function.
6. UV Lamp timer reset: If the UV Lamp is replaced, press the RESET button to
set the timer to zero.
7. HEPA filter timer reset: After the HEPA filter is replaced, press the RESET
button to set the timer to zero.
8. LED: Turns on / off the background LED light.
9. Intentionally removed.
10. TIMER: By pressing “TIME” button once, “88:88” will be displayed, press the
“+” & “-” buttons to set the current time. When the air purifier is turned on,
press the “TIME” button twice quickly, “88:88 time off” will be displayed, then
press the “+” & “-” buttons to adjust the time off. When the machine is on
Standby mode, press the “TIME” button twice quickly, “88:88 time on” will be
displayed, then press the “+” & “-” buttons to adjust the activation time
11. ANTI-POLLEN: Turns on the pollen-removing function. This mode of operation
is recommended for pollen season. The fan speed will run in a cycle of
medium speed for 5 minutes and low speed for 5 minutes.
8
•
The remote control is loaded with a CR2025 battery in advance. Before use,
please pull off the battery insulating plastic.
Aim the emitter of the remote control to receiver in the front of the air purifier.
The maximum signal transmission distance is approximately 15 feet.
Please change the battery if the signal is weak or if the remote control is
non-responsive.
•
•
9
INSTALLATION
1. The best location to install the air purifier is opposite a window or a door, this
creates optimal air circulation within the room.
2. If it is used in an air-conditioned room, place the air purifier opposite
the air conditioner, this creates optimal air circulation within the room.
3. Keep a distance of at least 3 feet of space between the air purifier and any equipment
which emits electric waves such as televisions, radios or wave clocks.
4. Ensure that there is at least a 6” clearance around the appliance. This allows for
adequate ventilation.
CLEANING & MAINTENANCE
To maintain the performance of the air purifier, regular cleaning of the unit and filters is
recommended.
► Cleaning the pre-filter
The pre-filter should be cleaned at least once a month.
•
•
•
Turn off and unplug the air purifier.
Remove the front cover and take out the pre-filter as shown in above pictures.
Rinse the pre-filter in warm water. Do not wash it in a washing machine or dish
washer. Do not use water hotter than 100F degree.
•
When the pre-filter is completely dry, place it back to the air purifier.
10
► Replacing HEPA filter
•
The HEPA filter needs to be replaced every 2,000 working hours or when the
HEPA icon flashes on the LCD display. The higher level of pollutants, the
shorter the lifespan of the filter.
•
•
•
Remove the front cover, the pre-filter and the old HEPA filter.
Install the new HEPA filter with the arrow in the front to the air purifier.
Press the HEPA “RESET” button on the remote control to reset the HEPA filter
timer.
•
Dispose of the old HEPA filter and do not reuse.
► Cleaning the photo-catalyst filter
The photo-catalyst filter should be cleaned every 6 months depending on the air
quality.
•
Remove the front cover, pre-filter and HEPA filter as shown in the above
picture.
11
•
Remove the photo-catalyst filter and use a vacuum cleaner with a nozzle or
brush attachment on lower power setting to clean the dirt and dust from the
filter.
► Replacing the UV Lamp
The UV lamp should be replaced every 15,000 working hours. This is indicated by the
blinking of the UV icon on the LCD display. Please contact Whynter’s service
department for purchase information of a new UV lamp.
► Cleaning the front cover
The surface of the air purifier should be cleaned at least once a month or more often
depending on the air quality.
•
•
•
•
•
Remove the front color from the air purifier.
Use a clean, dry cloth to wipe the external surfaces.
Use a damp cloth to remove stubborn stains and dirt build up.
Clean the air inlets and outlet with a dry cloth or a vacuum cleaner.
When dismounting or mounting the front cover, please be careful not to break
the hinge at the bottom of the front cover, otherwise this unit can not be turned
on. The block is a safety device which automatically cuts power off when the
front cover is opened.
12
TROUBLESHOOTING
Trouble
Check list
Solution
Unit does not start
There is a power supply failure
Ensure that the air purifier is plugged
in and the power outlet has power
The front cover is installed
properly
Install the front cover properly
Turn off the Child lock
Remote control does not
work
The Child lock may be on
The remote control has no
power
Replace battery in the remote
control
The remote control signal is
obstructed
Point the remote control directly
towards the front of the air purifier
Ensure the unit sits on a hard and
level surface. Do not place the unit
on carpet.
The air purifier is noisy and
vibrates
The unit is not level
Odor and smoke are not
removed
Filters are dirty
Clean or replace filters
The unit is unable to circulate air Install unit in a place where air is
able to circulate
Air does not flow from the
unit
Air inlets maybe obstructed
Unit is not reset
Ensure the air inlets are not
obstructed
The filter replacement
indicator remains on after the
filter is replaced
Press the reset button on the remote
control
Unit needs to be restarted
Restart the unit by unplugging it
13
ONE YEAR LIMITED WARRANTY
This WHYNTER air purifier is warranted, to the original owner within the 48
continental states, for one year from the date of purchase against defects in material
and workmanship under normal use and service. Should your WHYNTER air purifier
prove defective within one year from the date of purchase, return the defective part or
unit, freight prepaid (within two months of purchase; after two months to one year,
customer will be responsible for freight cost to Whynter’s service department), along
with an explanation of the claim to Whynter LLC. Please package the air purifier
carefully in its original packaging material to avoid damage in transit. Please retain the
original box and packaging material. Under this warranty, Whynter will repair or
replace any parts found defective. This warranty is not transferable. After the
expiration of the warranty, the cost of labor and parts will be the responsibility of the
original owner of the unit.
THIS WARRANTY DOES NOT COVER:
•
•
•
Filters
Acts of God, such as fire, flood, hurricanes, earthquakes and tornadoes.
Damage, accidental or other wise, to the air purifier while in the possession of
a consumer not caused by a defect in material or workmanship;
Damage caused by consumer misuse, tampering, or failure to follow the care
and special handling provisions in the instructions.
•
•
•
Damage to the finish of the case, or other appearance parts caused by wear.
Damage caused by repairs or alterations to the air purifier by anyone other
than authorized by the manufacturer.
•
Freight and Insurance cost for the warranty service.
To obtain service or information, contact
call 866-WHYNTER.
14
|